toshiba satellite radius p55w-b5318 laptop lcd touch screen complete assembly in

Ghost Touch, Running Touch, No-Touch, and Inverted Touch are not screen related issues. Kindly check your digitizer board and cable since they are the most likely cause of any touch issue; please do not open a return claiming the touch did not work. If the machine has a weakened or fragile digitizer board, the replacement unit or assembly will not have proper touch or in some cases it may not have touch at all.

Package includes the LCD screen + touch screen + bezel assembly ONLY. No extra touch control board, LCD cable, back cover, hinges, instruction or installation tools, etc.

Please kindly check your model and size again before you purchase. If you are not sure whether it is the correct item you need, please contact us with specific model and pictures of your original screen.

Shenzhen HaiXingKong Technology Co., Ltd. was established in 2012, is a burgeoning high-tech company providing laptop lcd screen,touch screen and laptop lcd assembly services. 6years Experienced in wholesale and retail, As a company committed to develop market of laptop screens HaiXingKong Is not only on its own economic, and efforts to service the vast number of consumers,To make more people find products in low prices and high quality.

This is also the development purpose of HaiXingKong Which located in the most advanced market in China,.HaiXingKong Technology Co., Ltd Committed to develop global laptop screen market and serve the consumers based on its strong funding and power technology.

Did anyone find out how to remove bubbles? Or just replace the inner screen - I assume the top layer of glass is kept? Only the inner screen gets replaced? Because the bubbles are along the non-black part of the display… I know that the bubble started as 1 tiny smudge from opening it with one hand… now there are multiple bubbles that interfere with operation. At times, the bubble sends a “click” because the screen flashes a zillion times until I restart it - its like having a stuck key except the stuck key is the bubble……

Since it is getting worse, I need to replace the part that has the bubble embedded. I don’t want to buy a new laptop, when its just a screen, and possible a fan (2nd time replacing it - but i run on ssd so it’s not as critical since it does not get hot ).

Item specificsCondition: Brand New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is available in a retail store, unless the item was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller"s listing for full detailsGrade:A+Resolution:1920x1080Size:15.6Brand:KreplacementModel number:For P55W-B seriesScreen Model:LP156WF5.SPA2 or a fully compatible modelAspect Ratio:16:9Screen type:IPSProduct type:Lcd screen+touch screen assembly with bezelCountry of Manufacture:chinaWarranty:120daysPacking:with bubble films in hard box

Today I’ll be replacing failed LCD screen assembly on a Toshiba Satellite Radius P55W laptop. I’m replacing the screen because of failed digitizer. The touch screen started showing bubbles and registering phantom touches on the screen.

In Toshiba Satellite Radius P55W laptop the LCD screen permanently attached (glued) to the digitizer. If either of them failed, the entire LCD assembly has to be replaced.

I’ve seen some eBay sellers offering touch screen digitizers separately but I really doubt you can replace it and make look factory perfect again. I tried separating the LCD screen and digitizer just to find out if it’s possible and the experiment failed completely.

It’s a good idea to disconnect the battery before taking apart the display assembly. I explained how to access the battery in this Toshiba Satellite Radius P55W disassembly guide.

Start separating the LCD screen assembly from the back cover on the top side of the display. Insert a thin case opener tool between two and pry up the LCD assembly.

Reconnect all internal cables and align the new LCD assembly with the back cover. Gently snap the new assembly back to the back cover. Start from the top and move the sides after that.