dynojet lcd display price

DescriptionThis LCD Display connects to the Power Commander V (PCV) via a quick disconnect cable. While connected, the unit will display all the available data from the PCV such as throttle position, RPM, percent of fuel change and injector duty cycle. The LCD Display utilizes a touch screen, making setup and navigation easy. It accepts a 1 GB SD memory card (1GB is the maximum useable size) to allow logging of data being displayedfor later analysis.

Display channels real-time: RPM, TP, map position (when using map switch), duty cycle, fuel change, speed, pressure, ignition change & wideband air/fuel ratio- (w/ WB2 or AutoTune connected)

In addition to the increased fuel adjustability the SFM provides, it also allows for the use of the Dynojet Quick Shifter sensor on 8 injector bikes. On earlier Power Commanders an Ignition Module or Stand Alone Ignition Quick Shifter was necessary to use the DQS on bikes with 8 injectors. Now, you can have both added fuel control and shifter functionality at a very low price. .

The MPS Hub Switch Relay Harness is designed to plug into the Dynojet Power Commander Hub and allow you to switch maps on the fly when your nitrous is activated. It can be wired to activate with either a 12 VDC positive signal or a ground signal.

Fuel and ignition timing (when using the Dynojet Ignition Module) adjustments can be made based on gear position or speed. If the user wants to advance the timing in lower gears while retarding it in higher gears this input makes that possible. (+/- 50% Fuel and +/- 10 Degrees of timing per gear)