3.2 tft lcd touchscreen display brands

Fully assembled 3.2inch display with 320x240 pixels TFT LCD and a resistive touch overlay. Just plug it on top of ODROID-C1. 2x13 tall female header is already soldered on the PCB.

Fully assembled 3.2 inch 320x240 display with resistive touch overlay.  Simply plug it into the SBC"s 26-pin or 40-pin header.  Leaves 14 pins unused on 40-pin header.  2x13 female header already soldered onto the PCB.

Ubuntu kernel add-ons to support this display can be easily downloaded to add software support for this display to your C1.  Super-easy installation script developed by ameriDroid is now available for Ubuntu on C1 (see INSTALLATION below). Automatic installation script may or may not work on other SBCs and OS distributions.

If you haven"t runapt-get dist-upgraderecently, go make yourself a cup of tea because it takes a little while update your entire OS.Once the C1 reboots after the installation process, your C1"s touchscreen will automatically be activated and will boot into the desktop.

Add some jazz & pizazz to your project with a color touchscreen LCD. This TFT display is really big (3.2" diagonal) bright (6 white-LED backlight) and colorful! 240x320 pixels with individual RGB pixel control, this has way more resolution than a black and white 128x64 display. As a bonus, this display has a resistive touchscreen attached to it already, so you can detect finger presses anywhere on the screen.

This display has a controller built into it with RAM buffering, so that almost no work is done by the microcontroller. The display can be used in two modes: 8-bit and SPI. For 8-bit mode, you"ll need 8 digital data lines and 4 or 5 digital control lines to read and write to the display (12 lines total). SPI mode requires only 5 pins total (SPI data in, data out, clock, select, and d/c) but is slower than 8-bit mode. In addition, 4 pins are required for the touch screen (2 digital, 2 analog) or you can purchase and use our resistive touchscreen controller (not included) to use I2C or SPI

We wrapped up this display into an easy-to-use breakout board, with SPI connections on one end and 8-bit on the other. Both are 3-5V compliant with high-speed level shifters so you can use with any microcontroller. If you"re going with SPI mode, you can also take advantage of the onboard MicroSD card socket to display images. (microSD card not included, but any will work)

Fully assembled 3.2 inch TFT LCD display with 320x240 pixels and a resistive touch overlay. Just plug it on top of the ODROID-C4 / N2 / N2+ / C1 / C1+ / C0.

You will need an official Ubuntu image to configure it. You can simply download the Kernel updates and configure your ODROID-C4 / N2+ / N2 / C1 / C1+ / C0 for this display shield.