g51 lcd display manual for sale

It is a smartLCD. You can not test it by only voltage. You need to install it on your E-Bike and pedal for 3-5 seconds. Then the LCD will show battery level normally.

Standard Connector Sequence Table Sequence No. Wire Colour Functions 1 Red（VCC） Display Power Cord 2 Blue（K） Controller Power Switch Cable 3 Black（GND） Display Ground Wire 4 Green（RX） Display Data Receiving Wire 5 Yellow（TX） Display Data Sending Wire

3. Functions a. Display Speed Display, Motor Power Ratio Display, Battery Level Display, Error Indication, Total Mileage, Single Mileage, Cruise Control, Brake Indication, Light Signal， b. Control and Setting Power Switch, Front Light Control, 6km/h Cruise Control, Real-time Cruise Control, Wheel Diameter Setting, 5-Gear Motor Power Setting, Top Speed Setting, Sleep Interval Setting, Backlight Brightness Setting, Voltage Level Setting c. Communications Protocol: UART

2www.czfound.com info@czfound.comwww.foundmotor.com info@foundmotor.comDisplay Details

3www.czfound.com info@czfound.comwww.foundmotor.com info@foundmotor.com Maximum Speed: MAX Average Speed: AVG Measuring Unit: MPH or KM/H The display will calculate the actual travelling speed based on the wheeldiameter and signal data (number of magnet steel is needed for Hall motors).

3.7 SettingsP00: Restore Factory Settings Set this value to 10 and switch to next setting,the display items will show all contents and restore original factory settings.P01: Backlight Brightness (1: darkest; 3: brightest)P02: Mileage Unit (0: KM; 1: MILE)P03: Voltage Class 24V / 36V / 48VP04: Sleep Interval(0: never, other value means display sleep interval) Unit: minuteP05: Power Assist Gear0/3 Gear Mode: Gear 1: 2V Gear 2: 3V Gear 3: 4V1/5 Gear Mode: Gear 1: 2V Gear 2: 2.5V Gear 3: 4V Gear 4: 3.5V Gear 5:4VP06: Wheel Diameter Unit: inch Precision: 0.1P07: Magnet Steel Number (for Speed Test) Range: 1-100P08: Speed LimitRange: 0-50km/h, parameter 50 indicates no speed limit.1. Non-communications status (panel-controlled)When the current speed exceeds the speed limit, the PWM output will be shutdown; when the current speed falls to lower than the speed limit, the PWM 4www.czfound.com info@czfound.comwww.foundmotor.com info@foundmotor.comoutput will be activated and the driving speed will be set as the current speed ±1km/h (only applies to assist power speed, not applicable to the handlebarspeed).2. Communications status (controller-controlled) The driving speed will be kept constant as the limited value. Error Value: ±1km/h (applicable to both the assist power/handlebar speed) Note: The above-mentioned values are measured by metric unit (kilometers).When the measuring unit is switched to imperial unit (mile), the speed valuedisplayed on the panel will be automatically switched to corresponding imperialunit, however the speed limit value in the imperial unit interface won’t changeaccordingly.P09: Direct Start / Kick-to-Start Setting 0: Direct Start 1: Kick-to-StartP10: Drive Mode Setting 0: Power Assist – The specific gear of the assist drive decides the assistpower value. In this status the handlebar does not work. 1: Electric Drive – The vehicle is driven by the handlebar. In this status thepower gear does not work. 2: Power Assist + Electric Drive – Electric drive does not work in zero-startstatus.P12: Power Assist Intensity Range: 0-5P13: Power Magnet Steel Number 5 / 8 / 12pcsP14: Current Limit Value: 12A by default; Range: 1-20AP15: UnspecifiedP16: ODO Zero-OutLong press the up key for 5 seconds and ODO value will be erased.P17: (Customer Designated) Auto Cruise Option. 0: No Auto-cruise1: Auto-Cruise On. Trigger time of auto-cruise is decided by the controller.P18: (K5S, APT Protocol Bound) Forward / Backward PAS Option.0: Forward. 1: Backward.P19: (K5S Protocol Bound) Throttle Level Option.0: No throttle level. 1: Has throttle levels.P19: (K5S Protocol Bound) 6km/h Cruise Throttle Definition. 0: Throttlehas no 6km/h cruise definition. 1: Throttle has 6km/h cruise definition.

Note: Due to product upgrade, the product you purchased may beslightly different from the descriptions in this user manual, and thiswon’t affect normal usage.

1.Heartbeat price: Collaborative pricing strategy of motor, controller,throttle&brake lever&switch,LCD&LED display,PAS,front light,cutting extra cost and helping with get more profit margins for customers

LCD-SW900 INSTRUCTIONS 1. Shell s Size and Material The shell s material is ABS. LCD screen is made of imported high hardness acrylic, and the hardness is equal to the tempered glass. Front View Side View

Product Specification 07/2014 Product Middle install intelligent LCD Display Mode Abbreviation C965A Client Customer audit Supplier Tianjin APT Development Co., Ltd. Room 609, Hi-tech Building H, No.6

Manual C963 Contents Preface 3 Appearance & size 4 Material & color 4 Function & button 5 Function 5 Display 5 Button 6 Attentions 6 Installation 7 Operation 7 ON/OFF 7 Interface 7 Assist walking 8 Backlight

EVBIKE LCD Display Control User Guide WWW.EVBIKE.CZ - 1 - Table of Contents: 1) Description of the individual components and installation 2) Description of the measured quantities and user control display

INSTALLATION MANUAL Wheel Drive Electric Bicycle Kit EVBIKE-SET-36V-26F EVBIKE-SET-36V-26R EVBIKE-SET-36V-28F Thank you for purchasing EVBIKE product and we hope that you will become a happy user. Carefully

TECHNICAL NOTE Edition Anglaise 77 11 205 445 JUNE 1999 Type 3239A Service 0422 Sub-section JE0 X BOSCH 5.3 ABS WITH SPEED INFORMATION FUNCTION Engine: Gearbox: XXX XXX Basic manual: N.T. 3034A This note

Trek Sensor 2.0 Cycling Computer Owners Manual Congratulations and thank you for purchasing your Trek Cycling Computer. Before operation please read this instruction manual carefully and retain it for

AA Portable Power Corp www.batteryspace.com, Email: Sales@batteryspace.com User Manual for CH-PFC76810 1. Overview The CH-PFC76810 charger is suitable for charging lithium ion battery packs such as those

Transmitter Interface Program Operational Manual Version 3.0.4 1 Overview The transmitter interface software allows you to adjust configuration settings of your Max solid state transmitters. The following

Thank you for purchasing our product. Please read this User s Manual before using the product. Change without Notice AWT07MLED 7 Q TFT LCD MONITOR (LED Backlighted) USER MANUAL e-4 SAFETY PRECAUTIONS Federal

User Manual EN FR DE for Terratrip GeoTrip IT ES PT Version V1.1, 06/02/13 User Manuals available at www.terratrip.com/manuals.htm Index. Page : Features... 3 1.0 Probe Selection:... 3 1.1 GPS receiver:...

SMS Alarm User Manual 1 1. Introduction... 2 2. SMSA1000 Specifications... 3 3. Parts Identifications... 4 4. Packing Contents... 5 5. Battery and SIM Card Installation... 6 5.1 Open the Back Cover...

OCSM Series High Resolution Digital Crane Scale Content 1. Safety Guide... 1 2. Features... 1 3. Specifications... 2 4. Capacity... 3 5. Display & Keys... 3 Scale & Remote Keys... 3 Indicators... 4 Message...

$2.50 Electronically Controlled Air Suspension (ECAS) for Trucks Maintenance Manual No. 36 Issued 7-99 ECAS System for 6 x 2 and 6 x 4 Vehicles with Rear Air Suspensions Service Notes Service Notes This

USER MANUAL EZRUN Series Brushless Speed Controller EZRUN-150A-PRO User Manual of EZRUN-150A-PRO Brushless ESC HW-SM405ENG-20130809 Page - 1 - Declaration Thanks for purchasing our Electronic Speed Controller

USER MANUAL US ESP Enhanced Steering Performance R-Net ESP Enhanced Steering Performance R-Net Produced and published by Permobil AB, Sweden Edition 1, 2008-04 Product code: 205229-US-0 How to contact

M3-ATX-HV 6-34V Intelligent ATX Power Supply Installation Guide Version 1.0c P/N M3-ATX-HV-01 Before you start Please take a moment and read this manual before you install the M3-ATX-HV in your vehicle.

Bluetooth + USB 16 Servo Controller [RKI-1005 & RKI-1205] Users Manual Robokits India info@robokits.co.in http://www.robokitsworld.com Page 1 Bluetooth + USB 16 Servo Controller is used to control up to

INSTALLATION MANUAL TRAILER LIGHTS CONTROLLER MODULE TYPE MP2-D1 / MP2-D2 QUASAR ELECTRONICS ul. Cieslewskich 25K 03-017 Warsaw tel. +48 (022) 678-68-96, 678-64-50 http://www.quasarelectronics.pl e-mail:

DMX2PWM 9 Channel Dimmer Setup Manual www.ecue.de DMX2PWM 9ch Dimmer - Setup Manual e:cue control GmbH An OSRAM Company Rev. 1.3_01/2010 DMX2PWM 9ch Dimmer - Setup Manual Table of Contents 1. Device Overview....................................4

An ISO 9001:2008 Registered Company ILISC515-A Shift Interlock (Manual Lift Door) 2015 Ford Transit, 3.7L and 3.5L Introduction The ILISC515-A is a microprocessor driven system for controlling wheelchair

Operation Manual For NDJ-8S Digital Rotary Viscometer 1 Contents 1. General... 2 2. Main technical data... 2 3. Working principle... 2 4. Installation... 3 5. Operation procedures... 4 6. Precautions...

ECO-WORTHY INSTALLATION AND OPERATION MANUAL INSTALLATION AND OPERATION MANUAL www.eco-worthy.com ECO-WORTHY Solar tracker ECO-WORTHY 400 Solar Tracker Owner s Manual Manual User Installation instructions

ELECTRIC BICYCLE OWNER S MANUAL For Owners of EG Bali 500EX and EG Milan 500EX Electric Bicycle Table of Contents Descriptions: Page Installation Instructions 2 How to install the bicycle out of the box

Manual EN BlueSolar Pro Remote Panel For BlueSolar PWM-Pro charge controllers 12/24V 5, 10, 20, 30A Article number SCC900300000 Contents EN 1.Important safety instructions... 2 2. Installation... 2 3.Product

E-Bike Conversion Kits Installation Manual Front Wheel Contents ( 一 )Getting started... Page 3 ( 二 )Tools List. Page 4 ( 三 )Removing and Installation of the wheel.. Page 5 ( 四 )Install the hand brake.....

INSTRUCTION MANUAL ---------- Remote Meter: MT-5 Remote meter (Model MT-5) is available to connect with solar controller Tracer MPPT series. OVERVIEW The digital Remote Meter displays system operating

QNVR range Quick Instalation guide Quick installation guide for the Vista Quantum QNVR Network Video Recorder Full manual found on the CD supplied with the NVR Contents SCOPE OF USE... 3 1. FRONT PANEL

Parts List quantity description 1 LCD-200 Display 1 LCD-200 Display cable 1 CD-ROM 2 dual lock or velcro 1 1GB SD card (optional) 1 CAN termination plug Navigation Main Menu Begin Log/Stop Log page 4 Log

HYDRA HV OPERATION MANUAL Starting Power Safe power on arming program helps prevent motor from accidentally turning on. Always use extreme care with high power systems. Auto shut down when signal is lost

CD/DVD Disc Duplicator Controller USERS MANUAL Introduction Features Model & Specification Control Panel Menu Overview Operation Guide 1. Copy 2. Test 3. Copy & Verify 4. Copy & compare 5. Verify 6. Compare

TREK INCITE 9i and 11i Bicycle Computer Owner s Manual This manual explains the installation and use of the Trek Incite 9i and 11i bicycle computer. Please read this manual carefully and save it for future

OCS-S High Resolution Digital Crane Scale Content 1. Safety Guide... 1 2. Features... 1 3. Specifications... 2 4. Capacity... 2 5. Dimension & Weight... 3 6. Display & Keys... 4 Scale Keys... 4 Indicators...

RADIANT PLASMA 4700 Plasma Spark Generator Installation Guide / User Manual A S P A R K O F F R E S H A I R Aquapulser.com Contents 1 Introduction 2 1.1 About the Product....................................

Multi Split Units If there is a fault on any LG Multi unit, an Error mark is indicated on the display window of the indoor unit, wired-remote controller, and LED s of outdoor unit control board. A two

Displays current altitude within 10 feet/4 meters. Records trip and total climb or descent (pat. pending). Measures 12 different performance factors for precise training. Posi-Click buttons & large display.

2 Phase Stepping Motor Driver 2M542 OPEATING MANUAL Table of contents Introduction page 2 Specifications page 2 Timing chart page 3 Setting page 4 Current set page 4 educe current function page 4 Micro

New GSM Alarm System User s Manual Profile For a better understanding of this product, please read this user manual thoroughly before using it. Chapter 1. Features Chapter 2. Alarm Host Introduction Chapter

User Manual Dual Laser InfraRed (IR) Thermometer MODEL 42570 Introduction Congratulations on your purchase of the Model 42570 IR Thermometer. This Infrared thermometer measures and displays non-contact

Quick-start Normal Mode: = Activate backlight manually = Switch between screens in normal mode = Start or stop the stop watch Data Setting Mode: = Enter data setting mode = Switch between screens in data

P2:This means the control for your Speed sensor if you doubt that you have an issue with the speed sensor so better to check the default value in your manual.

C5: This parameter is responsible for the maximum operating current & as we mentioned you can use this to reset your controller. please make sure to check your e-bike manual before changing any value.