printrbot lcd panel pricelist

I actually got it! The LCD screen works great! Now I just need to design and 3D print a housing mount for it (that"s the easy part). The following website helped me out a bunch:

The site above had a pretty good walk through on how to install it, pins and all. However, for troubleshooting, I enjoy YouTube screen casts because of the visual aspects it provides; so, and I may decide to make a video that walks the user through the process step by step. You were right, thankfully I did not need to flash the firmware, the printrboard was good to go. You are also correct about he SD connector, they do wear out. The good news is that my school where I work is less than 15 minutes away from printrbot headquarters; so, if something serious breaks down I can drive on over there. They have a new option on their website called the "bot spa" treatment where they tune up and work on printers. To help with the SD card problem, I actually ordered these adapters below (see link) to help ease the wear and tear on them and just utilize a standard USB cable.

If printrbot does not create a wireless method to print, I will definitely be upgrading to octoprint here soon. I hear nothing but good things about it. I follow the printrbot forums and I notice you help out alot! That"s awesome, thanks again for your help!

The following printers are being tested and are awaiting full write ups, but might have been featured on the channel or Instagram for a sneak peek