sony a7ii lcd screen replacement supplier

Thank you for your constructive comment. The criteria we needed to meet for this project was to provide instruction on iFixit guides for how to remove various parts on the device. We were being evaluated on the content pertaining to our writing and not the technical depth of the guide. Furthermore, we did not have a vested interest in replacing the screen nor did we have another screen to replace it with. In your rush to make a rude comment, you might have missed the end of the guide where it states that in order to reassemble you must follow the steps we provided in the reverse order. Reverse means doing something in the opposite direction.

7) Now you have to bring the board into the right position, if this is not done correctly the display will not engage as it should and there will be gaps here and there. That was my problem! I found out that the position was good enough when I pulled the board in way that the wide ribbon was lying tense and tight on the LCD backside.

Important: If you remove the screws there is a chance the described plastic part will fall out and it´s quiet hard to place it back again. Also in this tutorial a hint is missing that the frame has to be put back in first before reattaching the LCD.

A wide variety of lcd screen for sony options are available to you, such as original manufacturer, odm and agency.You can also choose from tft, ips and standard lcd screen for sony,

I replaced the flex cable (LC-1014) which is going from the motherboard to LC-1013 (PCB on the back of the LCD/hinge assy). That flex cable was my main suspect but that didn"t fix the problem.

But let"s assume LC-1014, the LCD itself, the motherboard AND the LC-1013 PCB are not the cause ... What else could this be? Because that"s about every component there is with regards to the LCD.