kd21c lcd display in stock

The Limited Warranty is expressly limited to the replacement of a defective lithium ion battery (the “Battery”), frame, forks, stem, handlebar, headset, seat post, saddle, brakes, lights, bottom bracket, crank set, pedals, rims, wheel hub, freewheel, cassette, derailleur, shifter, motor, throttle, controller, wiring harness, LCD display, kickstand, reflectors and hardware (each a “Covered Component”).

Attached list 2: Personality Parameter settings Screen Settings item display Battery Power Bar Settings Power assistant level Settings Over-current Cut Settings Power Assistant Sensor Settings Speed Sensor Settings Throttle Function Settings System Settings Power-on Password Settings Attached list 3：Power assist table...

2) Throttle may be broken. Disconnect the throttle and controller, take the throttle off from the bike. Push LCD “WALKING mode”= “-” button, if the bike is running, it means the throttle is broken. Throttle will need to be replaced.

1)  Remove the left brake lever, if error code 25 is still showing, then remove the right brake lever. Turn on LCD, If no codes are showing then Brake levers need to be replaced. Test one individually to see which one is giving the code. Another way to test is to remove Left, then right, and reinstall right first, then left while checking for codes everytime one is removed or installed.

I’ve come across 2 types of controllers. KD controllers and KT controllers. These controllers seems to be tied to their respective displays. The KD controllers can use KD displays, such a as the KD718. The LT controllers can use other displays, such as the LCD8H. From my findings, these are not compatible with each other. I was looking at swapping my display to the LCD8H, but I can’t find anywhere (yet) that can verify that will work with a KD controller. I think I’ll have to replace my controller, to a KT controller, to use the LCD8H. I also noticed that the rad upgrade, from Area13 (Bolton) cones with a KT controller. The stock rad controllers seem to be KD controllers. It is my understanding that KT and KD components are NOT compatible with each other.