mks 1.4+ tft lcd brands

I have a New MKS Gen-L V1.0 3D Printer Controller Board Relacement Ramps 1.4 Mega 2560 R3 and a KINGPRINT 12864 LCD Graphic Smart Display Controller Board with Adapter and Cable for 3D Printer Ramps 1.4 RepRap 3D Printer Mendel Prusa Arduino.

If you want to change some function or add new function and so on, you can refer to MKS TFT source code and build it, update it to MKS TFT, Link as below:

For more product dynamic information and tutorial materials, you can always follow MKS"s Facebook/Twitter/Discord/Reddit/Youtube and Github. Thank you!

The integrated mainboard driver MKS-GEN L V1.0 for 3D printer has been developed by Makerbase to optimize existing problems on the open source controller board such as Ramps 1.4.

The MKS Gen L V2.1 is recommended as the main board for the OAT when using NEMA steppers. It greatly simplifies the required wiring, which reduces the likelihood of hardware problems.

- Available for the 24V input, the hot bed current can be reduced to 1/4 with the same power of the system, which effectively solves the problem that the MOSFET of the heated bed is heated.

If you don"t intend to use the homing function, the board will work fine with the original firmware. Simply install it by following the instructions here. Use the MKS Gen L V1.0 board for CNC foam cutting.

MKS board is an control board for RepRap Prusa i3 3D compatible printer. This board has integrated Arduino Mega2560 and Ramps1.4 control board and make the circuit installation much simpler than before.

MKS Base board integrated 5 servo control model which does not included in MKS Gen 1.4 board. All other features of these two boards are same. We can use same Marlin firmware for both boards.