lcd module 1602a qapass datasheet pdf pricelist

LCD display for replacing a broken one or for creating something new. This LCD display can be used easily with Arduino, Raspberry Pi, Intel Edison or any other embedded system you want to work with.

Due to the ancient LCD controller technology made by Hitachi, the board controller requires 5VDC operating voltage. In order to easily use this display with say Raspberry Pi (3,3VDC) you need to hack this display a bit. In order to make it work with lower operating voltage, add a 8pin voltage converter such as ICL7660 (or similar) onto the space indicated with label U3. Then populate C1 and C2 with 10µF SMD capacitors and remove J1 solder bridge. To finalize the job enable the voltage converter by soldering a solder bridge across the J3 contact pins. You have now an LCD display capable of operating with lover operating voltage.

Directory  Summarize  Shape dimension  Module mainly hardware description  The external interface module  Command instructions  Ceading and writing operation sequence  Software initialization...

Summarize （1602A QAPASS ）is an industrial character type LCD, can also shows that 16 x02 namely 32 characters. (16 column 2 line) Second:module size (pictured) Three:pin interface specifications table Numbers symbols pin pin that Numbers symbols that Numbers symbols Pin that...

1 foot: for to power VSS. 2 feet: VDD take 5 V is power. 3 feet: VL for LCD contrast the adjustment, and then when the power is the weakest contrast, grounded contrast the highest, and the contrast Through high can produce the "ghost", when used, can pass...

4. 1602 LCD instructions in time sequence that 1602 LCD module internal controller of article 11 control instruction, as the chart shows: Numb instructions Clear display Cursor to return to Buy input mode Display the on/off control The cursor or character shift Buy function Buy character CunZhuQi...

4: control command table 1602 LCD module of reading and writing, and the screen and light mark operation operations are through the instructions of programming realize. (note: 1 for high Level, 0 for low level) Instruction 1: clear display, instruction code 01 H, the cursor is reset to address 00 H position. Instruction 2: the cursor reset, the cursor to return to address 00 H.

The basic operation sequence table Graph: read operation sequence Graph: write operation sequence 1602 LCD RAM address mapping and standard word stock list. Liquid crystal display module is a slow display device, so in the execution eachinstruction before must affirm module mark is busy low electricity Flat, said were not busy, otherwise this instruction failure.