floureon 7 inch capacitive lcd touch screen price

24 of the 232 reviewers have only reviewed this product. The One-Hit Wonders have rated this product an average of 3.0 while the reviewers who have posted more than one review have rated this product an average of 3.7. Based on our statistical modeling, the discrepancy in average rating between these two groups is significant enough to believe that the difference is not due to random chance, and may indicate that there are unnatural reviews.

17 of the 232 total reviews for this product are unverified purchases. This is within an acceptable range and it does not appear to be significantly affecting the overall rating for this product.

ER-TFTM070-5 is 800x480 dots 7" color tft lcd module display with RA8875 controller board,superior display quality and easily controlled by MCU such as 8051, PIC, AVR, ARDUINO, and ARM .It can be used in any embedded systems,industrial device,security and hand-held equipment which requires display in high quality and colorful image.

It supports 8080 6800 8-bit,16-bit parallel,3-wire,4-wire,I2C serial spi interface.Built-in resistive touch panel controller,it"s optional for resistive touch panel,capacitive touch panel and its controller FT5206,font chip, flash chip and microsd card slot. We offer two types connection,one is pinheader and the another is ZIF connector with flat cable mounting on board by default and suggested.

Of course, we wouldn"t just leave you with a datasheet and a "good luck!".Here is the link for7" TFT capacitive touch shield with libraries,examples,schematic diagram for Arduino Due,Mega 2560 and Uno. For 8051 microcontroller user,we prepared the detailed tutorial such as interfacing, demo code and development kit at the bottom of this page.

A 7-inch HDMI Touch Screen built in a case with integrated stand. Can be used for mini-PC"s like the Raspberry Pi or Jetson Nano, but also as a secondary screen for your computer.

Raspberry Pi Screen 7 Inch Capacitive Touch Screen TFT LCD Display HDMI Module 800x480 for Raspberry Pi 1/ 2/ 3/ Molde 3B + Black PC Various Systems 5-point Touch Control Drive-free Backlight Independent Control

Tips: Please use the HDMI cable and USB cable that comes with the product to connect the HDMI and USB ports of the motherboard. The USB interface of the USB cable is plugged into the USB interface of the motherboard for touch and power supply. .

Step 3: insert the Micro SD card into the Raspberry Pi, connect the HDMI cable to the Raspberry Pi and the LCD, connect the USB cable to any of the 4 USB ports of the Raspberry Pi, connect the other end of the USB cable to the USB port of the LCD, and then give the Raspberry Pi Power-on. If the display and touch are normal, the drive is successful (please use the 2A power supply).

2. Connect one end of the MicroUSB cable to the USB Touch interface of the LCD (any of the two MicroUSBs) and the other end to the USB port of the computer.