3.5 tft lcd shield ili9486 in stock

Shield for Arduino Uno consisting of a TFT LCD display with 3.5" resistive touch screen, ILI9486 graphic controller, 480x320 pixel resolution, 65,000 colors, white LED backlight, SD card slot and SPI interface. Ideal for creating applications that need to display data, photos and videos. Suitable for interfacing with Arduino Uno, it is also compatible with Fishino, Nucleo, Xnucleo, MAKERUNO and UNO PLUS (see related products).

The Arduino UNO module is a 3.5-inch TFT LCD module with 320×480 resolution and 65K color display. It uses 8-bit line parallel port communication, and the driver IC is ILI9486. The module includes an LCD display, 5V~3.3V level conversion circuit, which can be directly plugged into the Arduino UNO and MEGA2560 development boards, and also supports SD card expansion function.

Arduino Uno was designed explicitly for IoT hardware development and robotics application and many more memory hunger applications. In most of the electronics projects involving the Arduino, it would be extremely delighted to have a display through which we can monitor the vitals of our project. 3.5 Inch TFT Uno LCD Touch Screen display module designed specifically for Arduino Uno, using the latest Linux Core system. 3.5 inch TFT LCD display screen comes with a built-in microSD card connection.

This 3.5 Inch TFT LCD is a colour active matrix TFT liquid crystal display with a resistive touch screen. The TFT display provides a resolution of 480×320 pixels with colourful and 18-bit, 262,000 different kinds of shade, providing a better display. This 3.5 Inch TFT LCD Screen display has an ILI9486 controller IC which supports MCU Interface. In this, a resistive touchscreen is attached to the display, so we can detect finger presses anywhere on the screen. It is a 4-wire resistive touch screen with a 12-bit 125kHz sampling SAR type A/D converter.

This 3.5 Inch TFT LCD Screen display works on SPI Protocol (serial peripheral interface) to communicate with the main processor. It does not require any external power source or cases to mount it. 3.5 Inch TFT LCD Touch Screen highly recommended operating at a voltage alone 5V/2A power adapter. This is because the PC’s USB port may have not enough power to support both uno and LCD. Moreover, It supports the FBCP software driver, allowing it to configure software resolution, and set up dual-display. These display modules are mounted with high-quality immersion gold surface plating. This Touch Screen Module shield with Micro SD slot especially for UNO and MEGA, driven by ILI9486 Single Chip Driver.

This display can be mounted on an Arduino Mega or Due. It has a fairly high resolution of 320*480 pixels and is also quite large with 3.5 inch LCD size.

The 3.5 inch TFT LCD Touch Display Shield for Arduino Uno is fully assembled, tested and ready to go. Add the touch display without wiring, no soldering! Simply plug it in and load up a library – you’ll have it running in under 10 minutes! Works best with any classic Arduino ATMEGA328 Board

So spice up your Arduino UNO project with a beautiful large touchscreen display shield with a built-in microSD card connection. This TFT display is big (3.5″ diagonal) bright (4 white-LED backlights) and colorful (18-bit 262,000 different shades)!