ssd1963 tft lcd mikroc pic made in china

I have bought 2 x 5" East Riding TFT display which use the SSD1963 controller. My MCU is PIC32 795 and is connected with 8 data lines and then 16 data lines. Using 8 bit data lines and by using the configuration below the display can fill the screen with different colors correctly. The time to fill the screen with example 8 bit TFT_Fill_Screen(CL_red); is about 4 seconds. As this is too slow I have connected up 16 data lines but can not get this to work, I get a white flashing screen, I have tried many configurations but with no positive results. I am not sure if the problem is using PMP and also the 16 bit configuration, I also show this below. It is possible the SSD1963 timing requires the configuration data to be sent slower, so the using PMP might be an issue. Any ideas are welcome.

ER-TFTM090-1 is 800x480 dots 9"color tft lcd module display with SSD1963 controller board,superior display quality,super wide viewing angle and easily controlled by MCU such as 8051(C51), PIC, AVR, ARDUINO, and ARM and Raspberry PI .It can be used in any embedded systems,industrial device,security and hand-held equipment which requires display in high quality and colorful image.Portrait mode is also available.

Of course, we wouldn"t just leave you with a datasheet and a "good luck!".Here is the link for 9 TFT Touch Shield with Libraries, Examples.Schematic Diagram for Arduino Due,Mega 2560,Uno. For 8051 microcontroller user,we prepared the detailed tutorial such as interfacing, demo code and development kit at the bottom of this page.

ER-TFTM070-4V2.1 is the updated version of ER-TFTM070-4,that is 800x480 dots 7" color tft lcd module display with ssd1963 controller board,superior display quality,super wide viewing angle and easily controlled by MCU such as 8051, PIC, AVR, ARDUINO, and ARM .It can be used in any embedded systems,industrial device,security and hand-held equipment which requires display in high quality and colorful image.

Of course, we wouldn"t just leave you with a datasheet and a "good luck!".Here is the link for7" TFT capacitive touch shield with libraries,examples,schematic diagram for Arduino Due,Mega 2560 and Uno. For 8051 microcontroller user,we prepared the detailed tutorial such as interfacing, demo code and development kit at the bottom of this page.

it is easily controlled by 8051, PIC, AVR, ARDUINO, and ARM via MCU interface.It supports 6800, 8080 8-bit /9-bit/16-bit/18-bit/24-bit parallel interface.

The WF43QTIBEDBND is a 4.3 inch TFT LCD Display which is Winstar WF43H extended model with SSD1963 controller board plus a 36 pin-out connector on board. The model is available in 8080 family MPU 8 bit or 16 bit interface option and pre-defined pin no. 33 ~ 36 as backlight supply; so there is no need to design extra backlight circuit. This 4.3" TFT LCD panel is feature with Glare coating surface panel having benefited of less-reflective.

Winstar Q series is support with Solomon SSD1963 Which has the traditional inputs and drive TFT by VESA signal. Therefore, there is no need of T-COM circuit on board. Besides, we have integrated all functions including TFT connection, backlight driver, and touch panel into only one connection.