bac-601 lcd panel supplier

Hi all, I am new to the forum. I have built 3 E-bikes last year all kits 2 of which were Bafang mid drive kits and the third a GM Magic Pie rear hub. These Kits were all plug and play and a ton of info is available for programming these controllers so up until this point my e-bike experience has been all fun and games. Recently I was recruited to repair an existing e-bike direct drive rear hub the issue appeared to be faulty wiring at the controller caused some component damage and the controller was un-responsive. My course of action to correct was upgrade to a GM magic V2 25a controller and a BAC-601 smart display seemed like a home run the motor and battery conections are straight forward and the hal sensor connection was a direct fit, Brake switches handled and I figured out the throttle and power switch connection but the display hook up is another story. Does anyone out there have experience using these parts together. The Chat guy on the GM site said they were compatible and the controller would be programable from the display, but I cant find any usefull info on the net. Any help is greatly appreciated.

The LB104S01 is a Color Active Matrix Liquid Crystal Display with an integral Cold Cathode Fluorescent Lamp (CCFL) backlight system. The matrix employs a-Si Thin Film Transistor as the active element. It is a transmissive type display operating in the normally white mode. This TFT-LCD has 10.4 inches diagonally measured active display area with SVGA resolution(600 vertical by 800 horizontal pixel array). Each pixel is divided into Red, Green and Blue sub-pixels or dots which are arranged in vertical stripes. Gray scale or the brightness of the sub-pixel color is determined with a 6-bit gray scale signal for each dot, thus, presenting a palette of more than 262,144 colors.

Panel Size:9.4 inchDot Resolution:640×480 (VGA)Pixel Configuration:RectanglePixel Density:84 PPIAspect Ratio:4:3 (H:V)Form Factor:Flat Rectangle DisplayActive Area:191.97×143.97 mm (H×V)Landscape or Portrait:Landscape type

NU Tech Salesis a well-established firm engaged inManufacturing, supplyingandTradingessential components of Industrial Electronic and Touch Screen, Touch Monitor, White Board & other Touch solutions.LQ104V1DG11 LCD DISPLAY

This module is a color active matrix LCD module incorporating amorphous silicon TFT (Thin Film Transistor). It is composed of a color TFT-LCD panel, driver IC, power supply circuit and a back light unit. Graphics and texts can be displayed on a 320 × 240 × RGB dots panel with 262,144 colors by using 18bit digital signal interface (RGB×6bit), four timing signals, and supplying +3.3V DC supply voltage for TFT-LCD panel driving and supply voltage for backlight.

This module is a color active matrix LCD module incorporating amorphous silicon TFT (Thin Film Transistor). It is composed of a color TFT-LCD panel, driver ICs, control circuit and power supply circuit and a backlight unit. Graphics and texts can be displayed on a 640×3×480 dots panel with 262,144 colors by supplying 18 bit data signal (6bit/color), four timing signals, +3.3V/5.0V DC supply voltage for TFTLCD panel driving and supply voltage for backlight.

This module is a color active matrix LCD module incorporating amorphous silicon TFT (Thin Film Transistor). It is composed of a color TFT-LCD panel, driver ICs, control circuit and power supply circuit and a backlight unit. Graphics and texts can be displayed on a 640×3×480 dots panel with 262,144 colors by supplying 18 bit data signal (6bit/color), four timing signals,+3.3V/ +5.0V DC supply voltage for TFTLCD panel driving and supply voltage for backlight.

HannStar Display model HSD070IDW1-A is a color active matrix thin film transistor (TFT) liquid crystal display (LCD) that uses amorphous silicon TFT as a switching device. This model is composed of a TFT LCD panel, a driving circuit and a back light system. This TFT LCD has a 7.0 (16:9) inch diagonally measured active display area with 2400 x 480 dot (800 horizontal by 480 vertical pixel) resolution.

This module is a color active matrix LCD module incorporating amorphous silicon TFT (Thin Film Transistor). It is composed of a color TFT-LCD panel, driver ICs, control circuit, power supply circuit and a back light unit. Graphics and texts can be displayed on a 1024×RGB×768 dots panel with about 16 million colors by using LVDS (Low Voltage Differential Signaling) and supplying +3.3V DC supply voltages for TFT-LCD panel driving and supply voltage for backlight. It is a wide viewing-angle-module (Vertical viewing angle:170°Horizontal viewing angle:170°,CR≧10).

This Kyocera LCD module has been specifically designed for use only in electronic devices in the areas of audio control, office automation, industrial control, home appliances, etc. The modules should not be used in medical applications where module failure could result in physical harm or loss of life, and Kyocera expressly disclaims any and all liability relating in any way to the use of the module in such medical applications.

The LQ057Q3DC17 electronic component is brought into production by SHARP, included in LCD Liquid Crystal Display Modules. Each device is available in a small LCD package and specified over the extended temperature range of -40°C to 105°C (TA). CategoriesLCD Liquid Crystal Display ModulesManufacturerSharpPart NumberLQ057Q3DC17Lead Free Status / RoHS StatusLead free / RoHS CompliantConditionNew & Original Stock StatusIn-Stock InventoryEstimated Delivery Time1 Week

LM190E08-TLJ7 is a Color Active Matrix Liquid Crystal Display with an integral Cold Cathode Fluorescent Lamp(CCFL) backlight system. The matrix employs a-Si Thin Film Transistor as the active element. It is a transmissive type display operating in the normally white mode. It has a 19.0 inch diagonally measured active display area with SXGA resolution (1024 vertical by 1280 horizontal pixel array) Each pixel is divided into Red, Green and Blue sub-pixels or dots which are arranged in vertical stripes. Gray scale or the brightness of the sub-pixel color is determined with a 8-bit gray scale signal for each dot, thus, presenting a palette of more than 16,7M colors with Advanced-FRC(Frame Rate Control). It has been designed to apply the interface method that enables low power, high speed, low EMI. FPD Link or compatible must be used as a LVDS(Low Voltage Differential Signaling) chip. It is intended to support applications where thin thickness, wide viewing angle, low power are critical factors and graphic displays are important. In combination with the vertical arrangement of the sub-pixels, the LM190E08-TLJ7 characteristics provide an excellent flat panel display for office automation products such as monitors.

If you are looking for Gionee 601 LCD Screen supplier that offers good quality and competitive prices, you are in right place now. We will show some of our hot sale models.

In the past decade, LCD monitors have replaced CRT screens for all but the most specialist applications. Although liquid crystal displays boast perfect

Upgraded Display: The voltmeter with a large LCD color screen, and flashlight for easy reading even in bright or dim places. And the voltmeter can display analog bar, real-time temperature, low battery prompt, and damaged fuse prompt.