apple watch series 2 lcd screen and digitizer assembly replacement manufacturer

New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item is handmade or was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller"s listing for full details.See all condition definitionsopens in a new window or tab

The aluminum case Apple Watch is originally equipped with an Ion-X Glass face. The stainless steel or ceramic case is originally equipped with a Sapphire Crystal face. The two displays are functionally cross compatible but differ in their resistance to scratches, chips, and cracks.

This product can expose you to chemicals including lead which is known to the State of California to cause cancer and birth defects or other reproductive harm.

This Apple Watch (38 mm Series 2) screen replacement includes all of the small parts preinstalled in the assembly, saving time and increasing the quality of your repair.

Replace a cracked or scratched front glass panel or malfunctioning OLED display on your smartwatch. A new screen and digitizer assembly will renew the appearance of your front panel, restore touch function, and eliminate the dead pixels or flickering on an aging display.

Notice: the watch has a smaller body than phones and the battery inside is very easy damaged by heat. Also due to the size everything is packed in closer so apply minimal heat to prevent damage to the inner components.

After heating up the Apple Watch, insert a knife into the gap between the screen and the body, then use the case opening tool to pry it up little by little very gently. Take your time and go slowly. The screen will come apart, but it will take some work.

Pry up the 2 connectors. Notice: As the connectors are not set, you will need to press down one connector while you are prying up the other to prevent damage to the rest of the device.

Apple Watch use the tiniest Tri-wing screws we"ve ever see. We had no suitable tools to remove the screws, so we had to use a file to shape a PH00 screwdriver to fit. Fortunately, after losing 2 screwdrivers, we were able to make a suitable tool. Undo all 3 screws.

Notice: there are 2 strings connected with a coil of wire. If you don"t want to replace the part, you"d better not cut them off and lay the S1 SIP aside.

1. Every single digitizer assembly we shipped was strictly checked in good condition before shipping, so please be sure to check carefully after receiving it. If there is any damage, please contact us within 3 days.

3. For those digitizer assemblies HAVE BEEN INSTALLED AND CAUSED DAMAGE on appearance or labels, they are outside the scope of warranty, returning is not supported, please be kindly understood.

If your watch has image display issues, an unresponsive touch screen or physical cracks or scratches on the glass, this LCD and touch screen assembly is what you need

This is not an easy job for someone who has no technical skills with Disassembling or Assembling watch, so only purchase this item if you know how to install it

Highly recommend professional installation. We will not be held responsible for any damages to your watch that you may cause during the changing of replacement parts