s830 lcd display in stock

It is a smartLCD. You can not test it by only voltage. You need to install it on your E-Bike and pedal for 3-5 seconds. Then the LCD will show battery level normally.

Ebikeling LCD Display have multiple functions serving as a trip computer as well as controlling the whole ebike system on the conversion. Please see our installation menu for LCD manual.E Bike S830 LCD Display have multiple functions serving as a trip computer as well as controlling the whole ebike system on the conversion. These displays let the rider choose the assist level they desire if PAS is installed. They show remaining battery, current speed, average speed, maximum speed, total and trip distances. Wheel size can be changed for different applications. Compatible with the Ebike Conversion Kits

You have a display that communicates with the controller for pedal assist by analogue signal. P05 selects between 3 or 5 power levels. The controller is programmed to react to the voltage levels in the signal wire the same as if that were the throttle signal wire. You should be able to use either of the two settings. Although I said power levels above, they"re actually speed levels. In Chinese, gear means speed.

The throttle signal wire must be shared with the LCD"s pedal assist signal wire, which is why P10 doesn"t allow independent throttle and pedal assist at the same time, otherwise the pedal assist levels would work like a hands free throttle or cruise control.

1. Exterior Parameters Casing Material: ABS Display Material: High Hardness Acrylic (the same hardness value as tempered glass). Converter Ring φ 22.2mm 2. Single Supporter 2. Operating Voltage and Connections a. Operating Voltage: DC36v/48V Compatible (set by the control panel). b.

3. Functions a. Display Speed Display, Motor Power Ratio Display, Battery Level Display, Error Indication, Total Mileage, Single Mileage, Single Running Time Light Signal b. Control and Settings Power Switch, 6km/h Inching Control, Wheel Diameter Setting, Top Speed Setting, Time Setting for Auto-Hibernation, Backlight Brightness Setting, Voltage Level Setting c.

3.3 Multi-Functions Display Total Mileage: ODO Single Mileage: TRIP Single Running Time: Time Current Voltage VOL Operating Current: CUR DST: Unspecified 3.4 Vehicle Power PAS Lever 5 Levers Pedal Assist System 3. 5 Speed Display Maximum Speed: MAX Average Speed: AVG Measuring Unit: MPH or KM/H The panel will calculate the actual travelling speed based on the wheel diameter and signal data (number of magnet steel is needed for Hall motors).

3.7 Settings P00: it is Reset all parameter Function: Change the value as 10, then short press the “M” key, the screen will Display all segment, then all parameter will reset to the original value P01: Backlight Brightness (1: darkest; 3: brightest) P02: Mileage Unit (0: KM;...

Long press or Press Throttle to exit the cruise mode when the vehicle is in cruise mode. Long press to turn on/off backlight 4. Turn on/off the LCD Panel When the display panel is operating, long press and it will be turn off, oth- erwise it will be turned on.