tft lcd shield arduino nano price

Connector for connecting a TFT display 320x240 (displays of various diagonals 2.4", 2.8" and 3.2" can be used, as well as connecting the display both on one side of the board and on the back).

- Compatibility: Because the logic level is 3.3V, it is compatible with 3.3VforArduino board, you generally need to add a level conversion circuit if you use a 5VforArduino Board (forArduino UNO R3 /forArduino Mega2560 /forArduino Leonardo).

- Compatibility: Because the logic level is 3.3V, it is compatible with 3.3VforArduino board, you generally need to add a level conversion circuit if you use a 5VforArduino Board (forArduino UNO R3 /forArduino Mega2560 /forArduino Leonardo).

The 3.5" TFT LCD Touch Display Shield for Arduino has been fully assembled, tested, and is ready to use. Install the touch display without any wiring or soldering! Simply plug it in and load a library; you"ll be up and running in less than 10 minutes! It works best with any traditional Arduino ATMEGA328 board. So add a beautiful touchscreen display shield with a built-in microSD card connection to your Arduino project. This TFT display is large (3.5′′ diagonal), bright (4 white LED backlights), and colorful (262,000 different shades)!

The TFT display has 480x320 pixels and individual pixel control. It has significantly higher resolution than a black and white 128x64 display. As an added bonus, this TFT display includes a resistive touchscreen, allowing you to detect finger presses anywhere on the screen.

The control and driving circuit of TFT displaymodules is low voltage and FRIDA micro-power CMOS circuit, can be easily damaged by static, static damage is an irreparable damage, and sometimes human have hundreds of volts of high voltage static electricity, therefore, in handling, assembling and use should be extremely careful to prevent static electricity: