lcd screen deep scratch repair factory
I do take extreme care when replacing screens but the screen shattered on this one & the tool i was using to get the shattered bits of glass off slipped
Magic erasers are usually used for cleaning up messes, but could they clean up scratches? Yup. It wiped out small scratches on the phone"s screen in just a few seconds. Taylor Martin has a tutorial on how to make your own magic erasers for just around $0.10 (£0.07 or AU$0.14) each.
Wiping a screen with toothpaste (not the gel kind) supposedly works for fixing scratched screens. All it did in my tests was make the screen shinier and seemed to add small abrasion marks. I also tried toothpaste on a plastic screen protector, such as the kind that comes with OtterBox phone cases. It worked great on that! So it"s a no for screens, but a yes for plastic screen protectors.
Erasers work great for making scratches disappear. I used a white rubber eraser, but you can also use the type that"s found on the end of a pencil. Simply rub the scratch left and right with the eraser for about 60 seconds, and then rub it up and down for 60 seconds. The friction softens the eraser and it fills in the scratch. Don"t press down too hard, though!
Car waxes and headlight lens creams are supposed to be effective at removing scratches on screens, so I gave Mothers PowerPlastic 4Lights headlight cream a try. It made the scratches fade significantly, and l liked the shine it gave my screen.
A paste of two parts baking soda to one part water has been bandied about as a great screen fixer. Nope. It just made the screen really shiny. Plus, the moisture in the paste could damage your device.
According to the internet, coconut oil can solve just about any problem. Shockingly, it didn"t work well on phone scratches. Like with the petroleum jelly, it just made the phone super slippery.
I wasn"t sure about this tip. Sites say to mix the corn starch with a little water to make a paste, rub it on the screen with a soft cloth, and then wipe it off. It didn"t do anything to the scratches, but it made the screen shiny.
OK, this one freaked me out. A lot. Putting gooey, oily stuff on electronics is never a good idea, but I gave it a shot in the name of science. I dabbed a bit on as recommended, and rubbed it into the screen with a tissue. As I feared, all it did was make the test screen oily and sticky.
Why do people think it"s a good idea to rub food on their phones? Nope, rubbing a banana peel on your screen won"t help it. I tried it a couple different ways and it just left a crusty mess that is hard to remove.
Powdered cleanser like Bar Keepers Friend, Comet, Ajax and the like seem a good idea for buffing out scratches. They are slightly abrasive, so you"d think they"d polish your screen to a gleaming scratch-free shine. Well, they don"t. They can even leave new little scratches on your screen. Yah, this test didn"t go well.
Welcome to a guide on how to remove scratches on computer screens. Oh no! There is an ugly scratch mark on the screen, and it is very annoying every time you use the computer. Fear not. If the scratch is not too deep, there might still be hope with some “home and Internet remedies”.
Erasers are one of the most common and easy “remedies” that we techies use. Just use a soft rubbery pencil eraser (not those rough abrasive types) to gently rub on the scratch mark – It seems to work pretty well in removing light scratches, and it cleans off stubborn pieces of stuck dirt as well.
Have a very dirty screen with a lot of small scratches everywhere? Then you will need to get a cleaning cloth, some cotton buds, a soft brush, and cleaning alcohol (90% isopropyl alcohol from pharmacies will also do the trick).
First, apply the alcohol evenly over the screen. Be careful of the edges around the screen, and not get the alcohol inside – It will damage the electronics. Wipe it down with the cleaning cloth, and use cotton buds to target stubborn spots. This should pretty much restore any old screens back into their “shiny state”.
Note – I know the above is not a “scratch repair” video, but that is a very good demonstration of how to restore an old computer screen using cleaning alcohol.
There are actually quite a lot of these “Mythbusters” videos on the Internet that toothpaste does not remove scratches. Personally, I have tried it and it works – But only on micro scratches.
Lastly, apply the toothpaste to the screen, use a cleaning cloth and rub it in a circular manner – The whole idea is to use the toothpaste as a screen polish.
This is another trick that we techies use to hide the scratches, and yep, just about any petroleum jelly-based product will work. All we need is to gently rub the cream into the “scar”, it should start to “blend in” and fade the scratch mark. Take note though, that it seems to only work on matte plastic screens and not the glossy glass ones.
This is kind of an “enhanced method” of the above windscreen polish. If there are a lot of micro-scratches on the screen, you can try applying a wet piece of very fine sandpaper (2000 grit) in circular motions to get rid of them first.
Then, complete the treatment with windscreen polish and car wax. The whole process requires quite a lot of elbow grease and patience, but it does restore the screen back to its “default factory shiny state”… Maybe even better.
Once upon a time in the bronze age of the Internet, people would use mashed bananas and baking soda to repair the scratched CDs… A very eco-friendly way of repairing stuff, non-toxic too. If it works on the plastic of a CD, then it should also technically work on plastic computer screens.
Personally, a combination of cleaning alcohol and Vaseline seems to work the best; Cleaning alcohol to remove the gunk, and Vaseline to cover the micro scratches. But take note, this worked on plastic screens, not glass.
If you run your fingers across the scratch mark, and it catches your fingernail. That is probably too deep to be fixed with the above home remedies, and it’s better to replace the entire screen.
I just got my NIB WOZ ECLE this evening and have been really enjoying it. After getting my initial games in I decided to update the software and while taking the time to closely examine things I noticed what I thought was a hair on the back glass. When I looked closer I saw that it was actually a scratch on the monitor underneath the glass. When I removed the back glass I could also tell that I was not the first to notice since with the glass off I could see there were smudgy finger prints across the scratch where I guess someone tried to rub it out with their finger. So while it"s a little disappointing that the scratch was noticed at the factory and not handled there I totally understand that things happen it was probably small enough to not trigger any action. After all it"s barely noticeable and had I not been staring at the screen watching the update I probably would never had noticed just playing the game.
So my question is, is there a safe way to remove a scratch from the WOZ LCD screen? I guess it really applies to any LCD screen. The scratch is small (about 1/2" long but deep enough that running a soft cloth over the area i can feel a slight ridge.
{"smallUrl":"https:\/\/www.wikihow.com\/images\/thumb\/2\/2e\/Fix-a-Scratch-on-an-LCD-Screen-Step-10-Version-4.jpg\/v4-460px-Fix-a-Scratch-on-an-LCD-Screen-Step-10-Version-4.jpg","bigUrl":"\/images\/thumb\/2\/2e\/Fix-a-Scratch-on-an-LCD-Screen-Step-10-Version-4.jpg\/aid22855-v4-728px-Fix-a-Scratch-on-an-LCD-Screen-Step-10-Version-4.jpg","smallWidth":460,"smallHeight":334,"bigWidth":728,"bigHeight":529,"licensing":"
Use our “Get an Estimate” tool to review potential costs if you get service directly from Apple. The prices shown here are only for screen repair. If your iPhone needs other service, you’ll pay additional costs.
Your country or region offers AppleCare+ for this product. Screen repair (front) is eligible for coverage with a fee by using an incident of accidental damage from handling that comes with your AppleCare+ plan.
Replacement equipment that Apple provides as part of the repair or replacement service may contain new or previously used genuine Apple parts that have been tested and pass Apple functional requirements.
Accidental Damage is any damage due to an unintentional act that is not the direct result of a manufacturing defect or failure. Accidental damage is not covered under the standard warranty of the product. Such damage is often the result of a drop or an impact on the LCD screen or any other part of the product which may render the device non-functional. Such types of damage are only covered under an Accidental Damage service offering which is an optional add-on to the basic warranty of the product. Accidental Damage must not be confused with an occasional dead or stuck pixel on the LCD panel. For more information about dead or stuck pixels, see the Dell Display Pixel Guidelines.
NOTE: Other damages may be considered customer induced if determined by Dell Technical Support, an on-site field engineer, or at the mail-in repair center.
The LCD glass on the display is manufactured to rigorous specifications and standards and will not typically crack or break on its own under normal use. In general, cracked, or broken glass is considered accidental damage and is not covered under the standard warranty.
Internal cracks typically occur due to excessive force on the screen. This can be the result of some object hitting the screen, a drop, attempting to close the lid while an object is on the keypad area, or even holding the laptop by its screen.
Spots typically occur due to an external force hitting the screen causing damage to the LCD panel"s backlight assembly. While the top layer did not crack or break, the underlying area was compressed and damaged causing this effect.
If your Dell laptop LCD panel has any accidental damage but the laptop is not covered by the Accidental Damage service offering, contact Dell Technical Support for repair options.
Dell monitors cannot be repaired by an on-site field engineer or at the mail-in repair center. If you notice any damage to the monitor, you must purchase a new monitor.
To clean minor scratches from the car radio screen, first put a small amount of toothpaste on your finger and apply it to all scratches on display. Then use a microfiber cloth and start rubbing the scratched area in a circular motion. This will clean all minor scratches on the screen and make the display crystal clear.
Tip:There are various other methods that are very effective in removing scratches for car radio screens, depending on their size, but regardless of which way you use, make sure you use a soft brush that will not create more than already existing scratches on display.
In this article, I will dig deep into removing car radio scratches, what causes them to appear, and how you can prevent the screen from happening again.
Radio screens are used for navigation and as a display. Many cars nowadays have factory-installed touch screen stereos, which because being often touched are easy to get dirty or scratched.
As we know, screens attract dust particles due to charge induction, and you can see these particles on the screen when light falls onto them. When you touch the screen of stereo with dust particles on it, this leads to scratches. Another reason for scratches is not usingglass protectoron the screen.
The dust particles in the air are the number one cause of starches on car stereo screens. This is because the car stereo screens are positively charged, and due to this, a static negative charge is induced in dust particles.
This induction of charge attracts dust towards the radio screen, and it gets stuck to its surface. If you live in a polluted environment near the coast, you will find more dust particles on the screen than in other areas.
When you use your fingers to touch the screen or swipe up or down, your finger will rub against the dust particles, which will cause scratches on the screen.
These dust particles harm not only your screens but also your health, and this is the reason why people nowadays use cabin air filters which you should often replace.
But regardless if your car has a cabin filter or not, to keep the screen in good and clean condition, you should regularly clean the dust particles with a dry microfiber cloth.
If you touch the screen with dirty hands or use the car key on the touchscreen, then do not be surprised if it does not look brand new after a short time.
Car stereo scratches are a problem many car owners face because the car touch screen is sensitive, especially if you have a radio with a resistive screen, which is more susceptible to scratching or wear.
The good news is that you can remove scratches by using simple things. For example, you can use toothpaste, baking soda, vegetable oil, or QUIXX 10003 Acrylic Scratch Remover.
In most cases, you will remove the scratch all by yourself, but it may happen, especially when the screen was touched by something sharp and the scratch is deep, that you have to leave the car with a professional.
I recommend cleaning your car stereo screen once a month while you are washing your car. First, I use a vacuum cleaner with a soft brush to suck off the dust from my dashboard and screen. Then I use Shine Armor plastic spray cleaner to clean the whole dash and screens and wipe it dry with a microfiber cloth.
Rub toothpaste cloth gently on the car stereo screen in a circular motion. Don’t put pressure on the screen, otherwise, it will harm your car stereo touch functionality.
Baking powder is an effective and cheap solution for removing car stereo screen scratches or other surface scratches, and to make it right, follow the steps below:
In addition to all the above procedures, there is one more way to make the radio screen look brand new. Actually, the results are the best, and you can not only remove the scratches but completely restore the radio screen that has a matt effect.
Before starting, cover the surrounding buttons of the stereo with masking tape so you will polish only the screen. Also, you do not need the polishing paste inside the buttons.
Take a tiny dot of polishing paste and place it on the pad. Start the machine polisher and clean the car radio screen gently. Some polishing pasts require a screen or glass to be wet before polishing, so check how to proceed with the paste you use.
In most cases, I have my screen clean after the first try, but it depends on the scratches’ depth. If still visible, you may need to repeat the process, but do not use a more aggressive paste on the screen.
Minor scratches do not affect the functionality of touch screens, and the displays work fine. However, larger and deeper scratches that reach the touch screen membrane can affect the screen’s responsiveness and color transparency. In the worst cases, your screen can become unresponsive to the finger touch.
Touch screens work by responding to light and pressure with a change in electrical resistance. If the screen is scratched, it will change the resistance pattern, causing errors and lowering response time.
To protect your radio screen from scratches, you can use a plastic screen protector of the same size as the screen. These screen protectors are well known for their ability to protect infotainment screens from dust, dirt, scratches and have superior strength.
Here are some popular protective glasses available in the market that I recommend using, especially if your radio is at a higher risk of being scratched.
This protection film for standard 2-din car radios comes in two pieces, depending on how shiny effect you want to achieve. One is Frosted Film and one High Definition film. Both are for 7″ screens and are really easy to apply.
You can add the designated screens for the specific car models when you have a factory-installed car stereo with customized screens. I listed below a few examples for popular car models:
The best way to ensure your screen’s protection from scratch damage is by applying a plastic film protector that will keep your device safe from scratches.